Tingting Li, Jiong Zhao, Jing Li, 等. Microstructure analysis and compressive performance of diamond/Al2O3 composites by digital light processing technology[J]. Functional Diamond, 2026,6(1).
Tingting Li, Jiong Zhao, Jing Li, et al. Microstructure analysis and compressive performance of diamond/Al2O3 composites by digital light processing technology[J]. Functional Diamond, 2026, 6(1).
Tingting Li, Jiong Zhao, Jing Li, 等. Microstructure analysis and compressive performance of diamond/Al2O3 composites by digital light processing technology[J]. Functional Diamond, 2026,6(1).DOI: 10.1080/26941112.2026.2705639.
Tingting Li, Jiong Zhao, Jing Li, et al. Microstructure analysis and compressive performance of diamond/Al2O3 composites by digital light processing technology[J]. Functional Diamond, 2026, 6(1).DOI: 10.1080/26941112.2026.2705639.
Microstructure analysis and compressive performance of diamond/Al2O3 composites by digital light processing technology
摘要
Abstract
lumina (Al
2
O
3
) ceramics with complex geometry are widely used in aerospace thermal components
cutting tools
and catalyst supports because of their excellent thermal stability
corrosion resistance
and wear resistance. However
low ductility problem existed in such brittle material and influences its long-term stable service in extreme environments
especially under load-bearing conditions. Adding carbon material were considered as an effective method to improve mechanical properties of ceramics. In this work
diamond/Al
2
O
3
composites were fabricated using digital light processing (DLP) additive manufacturing technology. Meanwhile
their microstructure
phase composition
and compressive properties were systematically investigated here. After sintering treatment
Al
2
O
3
particles retained a well-defined morphology and unchanged phase composition
which had an average particle size of 6 μm. Diamond particles had an average particle size of 1 μm and transformed obviously from a crystalline structure to an amorphous state
accompanied by characteristic graphitization peaks. From mechanical properties testing results of DLP composites
the specimens exhibited elastic modulus of 331.23 ± 8.69 MPa and compressive strength of 46.19 ± 1.07 MPa. Specially
diamond/Al
2
O
3
composites specimens had an increasing i
n elongation (27.26 ± 0.17%) compared with pure Al
2
O
3
specimens. This indicated carbonized diamond particles had a positive effect on enhancing the ductility of Al
2
O
3
ceramics. These scientific finding will provided an important reference for investigating additive manufacturing high-performance ceramics.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.